Fire Building Construction: Connections: Lightweight Steel Trusses

These lightweight steel trusses are fabricated from galvanized steel strips that have been rolled into shapes to add strength. They are commonly used in residential and commercial construction. Photo 1 shows these trusses being set in place to support the roof of a veterinary clinic. Photo 2 shows these trusses in place to support the roof of a school building.

Photo 3 shows the end view of a bundle of trusses. Note that the cross-section of a top or bottom chord has eight 90° bends as well as several other bends, which give these truss members great rigidity when compared to the flat strip of steel from which they were formed.

Photo 4 shows the end view of trusses by another manufacturer. Note that the cross-section of a top or bottom chord has six 90° bends plus two longitudinal ribs, which give these truss members great rigidity when compared to the flat strip of steel from which they were formed.

Self-drilling screws are the most common way to assemble the trusses at the factory and connect them to the walls and other load-bearing members at the building site.

In photos 3 and 4, note that a single screw will penetrate all of the layers of the components of a truss and that several screws will be used at each panel point. These screws are designed to be installed with electric or pneumatic screw guns. The screw gun uses the drill tip of the screw to make a hole through the layers of metal to be jointed. As part of the same procedure, the screw threads into the hole when drilling is complete. An adjustable clutch on the screw gun allows the operator to set the gun so that the completed screw connectors have the proper amount of torque for maximum strength. If the clutch on the screw gun is set too tight, the screws may strip in the metal of the studs, making a loose or weak joint. If the screws are not driven home, the joint will also be weak. In either of these cases, adding moisture from weather or leaky pipes will accelerate the rusting and weakening of the joints.

Wood screws are used to connect lightweight steel truss to a wood top plate on a wall, while self-drilling screws are used to connect a steel joist or steel stud assembly. If the truss has members configured, as shown in photo 4, drive the screws through the bottom flange of the truss member. If the configuration is similar to what is shown in photo 3, you can use attachment plates (photo 5) to connect the truss to the top of the wall.

Firefighters working inside a building with a roof supported by this type of truss should be concerned with the following:

Gregory Havel is a member of the Town of Burlington (WI) Fire Department; retired deputy chief and training officer; and a 35-year veteran of the fire service. He is a Wisconsin-certified fire instructor II, fire officer II, and fire inspector; an adjunct instructor in fire service programs at Gateway Technical College; and safety director for Scherrer Construction Co., Inc. Havel has a bachelor’s degree from St. Norbert College; has more than 35 years of experience in facilities management and building construction; and has presented classes at FDIC.

Sponsored Content is made possible by our sponsor; it does not necessarily reflect the views of our editorial staff.

Stay up to date on everything FireEngineering. Click the buttons below to learn more about how to subscribe.


Post time: May-17-2019
WhatsApp Online Chat !